MINI MAGAZINE CARD HOLDER


Cardstock cut at 11” x 12”.

On the 11” side, score at 6 ½ x 4 ½ - On the12” side, score at 6” & 10 ½.

On the 12” side, cut up on the 10 ½ inch score-line to 6 ½ inch score-line on both sides.

Then, on the 12” side, cut up on the 6” score-line to 6 ½ inch score-line on both sides.

Score the middle flaps in 2 ¼ inches on both sides.

Fold all score-lines.

On top panel, measure out ½ inch from each score-line & make a small mark.

On top panel, measure up 2 ½ inches from the bottom & make a small mark.


Then, on each side cut from mark to mark. At this point your project should look like the picture below.

Cut DSP to decorate the outside. I used 2 pieces of DSP at 1 7/8” x 4” & 1 piece at 5 ¾” x 1 7/8”. I also used 11” of ribbon to make the bow.

Adhere the DSP & Embellishments before assembling the holder.

Then fold in bottom & top & adhere to make a holder.


Perfect to give a gift of handmade cards to someone!


HUGS,

PATTI

I am responsible for all of the content on  this site.

No product brand endorses the use of products and/or contents

of the classes or services I provide  or use/offer/show here on my site.

© Patti